200 RPM Side Shaft 37mm Diameter Compact DC Gear Motor

Introduction

200 RPM Side Shaft 37mm Diameter Compact DC Gear Motor is suitable for small robots / automation systems. It has sturdy construction with gear box built to handle stall torque produced by the motor. Drive shaft is supported from both sides with metal bushes. Motor runs smoothly from 4V to 12V and gives 200 RPM at 12V. Motor has 6mm diameter, 22mm length drive shaft with D shape for excellent coupling.

Table below gives fairly good idea of the motor’s performance in terms of RPM vs voltage at no load and that of stall torque at different voltages.

Important Note: This motor will be bit noisy while running. For long life, this motor is not recommended for application requiring dynamic torque of more than 3 kg-cm.

Specifications

• RPM: 200 at 12V
• Voltage: 4V to 12V
• Stall torque: 4.4Kg-cm at stall current of 1.3Amp.
• Shaft diameter: 6mm
• Shaft length: 22mm
• Gear assembly: Spur
• Brush type: Carbon
• Motor weight: 143gms
• Dimension: Refer to diagram below

Note: This is representative torque. Actual torque may vary by ±20%

Recommended wheels

Any wheel with 6mm diameter bore can be used with this motor
Universal Wheel
87mm Diameter Multipurpose Wheel for 6mm Shaft Gear Motors
87mm Diameter Multipurpose Wheel for Plastic Gear Motors
70mm Diameter x 19mm Thick x 6mm Bore Wheel
70mm Diameter x 36mm Thick x 6mm Bore Wheel
106mm Diameter x 44mm Thick x 6mm Bore Wheel
109mm Diameter x 21mm Thick x 6mm Bore Wheel

Recommended Chassis: 4 Wheel Drive Robot Chassis (Small)

Recommended Motor drivers for large loads

8V-28V, 5Amp Dual DC Motor Driver with Current Sense
L298 46V, 2A Stepper Motor / Dual DC Motor Driver

Recommended Motor drivers for moderate loads:

TB66FNG 13.5V, 1A Dual DC Motor Driver
L293D Motor Driver IC

Package contains

200 RPM Side Shaft 37mm Diameter Compact DC Gear Motor

Visit forum for Online Discussion on this product

Customer Reviews: