NEX AVR USB ISP STK500V2

Introduction

NEX AVR USB ISP STK500V2 is a high speed USB powered STK500V2 compatible In-System USB programmer for AVR family of microcontrollers. For Windows7 it can be used in HID mode with Avrdude command prompt as programming interface. Its adjustable clock speed allows programming of microcontrollers with lower clock speeds. The programmer takes power directly from PC’s USB port which eliminates need of external power supply. The programmer can also power the target board from PCs USB port with limited supply current of up to 100mA.

Note: The USB port of PC provides 5V DC. For 3.3V microcontrollers, please use appropriate voltage regulators.

Note: NEX Robotics USB ISP programmer GUI has not been tested on 64-bit operating system.

The NEX AVR USB ISP STK500V2 comes with an easy to use GUI for programming the AVR family of microcontrollers. The GUI works on Windows 7(32 Bit), Windows Vista(32 Bit) and Windows XP(32 Bit) please set the NEX AVR USB ISP STK500V2 programmer to HID mode for use with GUI.

Note: Please set the NEX AVR USB ISP STK500V2 programmer to HID mode for use with GUI.
Loading bootloader.a90 file (available from Nex-Robotics) via STK500v2, will take approximately 15 minutes on certain microcontrollers like ATmega2560.

Note: If mode is HID, insert HID/CDC jumper (J2) and if mode is CDC, remove HID/CDC jumper (J2).

Note: We have tested stk500v2 programmer on ATmega8, ATmega16, ATmega32, ATmega64, ATmega128, ATmega640 and ATmega2560. We will provide support only for the above mentioned microcontroller. Technical support will not be provided for other microcontrollers.

Downloads

NEX AVR USB ISP STK500V2 GUI

NEX AVR USB ISP STK500V2 User Manual

USB Drivers and Software

Features

• Low cost USB compatible (No legacy RS232 required)
• Compatible with STK500V2
• Supported by AVRdude on Win7/XP/Vista
• Jumper adjustable programming clock speeds for low clock speed microcontrollers. Low speed ranges from 32 KHz to 1MHz.
• Programs almost all AVR microcontrollers (Refer Table below)
• Jumper selectable HID/CDC mode.
• USB powered
• Jumper enabled 5V power supply for target boards
• Standard 10 pin (5x2) programming connector
• Power and programming activity indicator LEDs
• No external power supply required

Package Contains

• 1 x NEX AVR USB ISP STK500V2
• 1 x 10 Pin FRC Cable
• 1 x USB Cable

Supported AVR Microcontroller

Customer Reviews:

You may also be interested in this/these product(s)

ATMEGA128 Board Rs.780.82