Ultrasonic Range Finder LV Maxsonar MB1010 EZ1

Introduction

EZ1 (EZ Series) is an indoor, compact, low cost easy to use ultrasonic range sensor with narrower beam width than EZ0 Ultrasonic sensor from MaxBotix. EZ1 is great choice for use where sensitivity is needed along with side object rejection. It gives range output in terms of analog voltage, serial data and PWM signals. You can cascade many of these sensors together to take distance reading of the surrounding area without any interference from the adjacent sensor.
To select correct sensor for your application refer to Sensor Selection Guide
With 2.5V - 5.5V power the EZ1 provides very short to long-range detection and ranging, in an incredibly small package. It detects objects from 15cm to 645 cm (6 inches to 254 inches) with the resolution of 2.5cm (1 inch). Objects closer than 6 inches range as 6 inches. It gives range output in the Analog, Pulse Width Modulation (PWM) and in the serial format which makes it very convenient for interfacing. EZ0 to EZ4 sensors have progressively narrower beam width. Select sensor according to your application.

Specifications

• Wide Beam angle (EZ1 sensor Beam width explanation)
• Range: 15cm to 645cm (6 inches to 254 inches)
• Resolution: 2.5cm (1inch)
• 2.5V to 5.5V supply with 2mA typical current draw
• Range data output format:
  -Analog: (Vcc/512)/inch
  -Pulse Width Modulation (PWM): 147uS / 2.5cm or 147uS / inch
  -Serial (9600 baud rate)
• Data refresh rate: Up to 50 milliseconds (20Hz)
• Free run mode operation: continually measure and output range information
• Triggered mode operation: provides the range reading as desired
• Sensor operating frequency: 42KHz

Note:

Sensor part numbers are combination of a six characters base followed by a dash and three digit product code.For more details about product code Click Here

Dimensions

Documents

EZ1 sensor datasheet
EZ1 sensor Beam width explanation
Maxbotics FAQ

Sensor Selection Guide:

Visit forum for Online Discussion on this product

Customer Reviews: