ATMEGA32 Development Board

Introduction

ATMEGA32 Development Board is made from double sided PTH PCB board to provide extra strength to the connector joints for increased reliability. Board can work on 7 to 15V AC or DC supply. It has built-in reverse polarity protection. 7805 voltage regulator has heat sink for heat dissipation so that it can supply 1Amp current continuously without getting over heated. It has switches for boot loading, reset and power. It also has RS232 interface with DB9 female connector based on MAX232. All the ports are connected to standard 10 pin FRC connectors. Open pads for connecting microcontroller’s pins to external devices are also provided.

Specifications

• Microcontroller: ATMEGA32 with 14.7456MHz crystal (Also supports ATMEGA16)
• Double side high quality PTH PCB for added strength.
• Power: 7 to 15V, AC or DC, Heat sink on 7805 for better current rating
• Reverse polarity protected
• Switches: Boot, Reset, Power
• RS232 serial interface
• 10 pin FRC connectors and soldering pads on all ports
• Compatible with General purpose prototyping board for development board for stackable design
• Application examples in AVR studio provided in the documentation CD

ATMEGA32 Microcontroller Features

• Advanced RISC Architecture
• Up to 16 MIPS Throughput at 14.7456 MHz
• 32K Bytes of In-System Self-Programmable Flash
• 1024 Bytes EEPROM
• 2K Byte Internal SRAM
• 32 Programmable I/O Lines
• In-System Programming by On-chip Boot Program
• 8-channel, 10-bit ADC
• 8 Single-ended Channels
• 2 Differential Channels with Programmable Gain at 1x, 10x, or 200x
• Two 8-bit Timer/Counters with Separate Prescalers and Compare Modes
• One 16-bit Timer/Counter with Separate Prescaler, Compare Mode, and Capture
• Real Time Counter with Separate Oscillator
• Four PWM Channels
• Programmable Serial USART
• Master/Slave SPI Serial Interface
• Byte-oriented Two-wire Serial Interface
• Programmable Watchdog Timer with Separate On-chip Oscillator
• External and Internal Interrupt Sources
• 40-pin PDIP package

Package contains

• ATMEGA32 Development Board (With ATMENGA32 Microcontroller)
  
• CD containing user guide, example codes in AVR studio and software

AVRISP mkII USB Programmer	NEX AVR USB ISP STK500V2
12V, 1Amp SMPS power supply for the development board with Isolation between mains and DC supply.	Female 1 to 1 Connector Pack of 10

Bootloader utility for loading firmware via USB port of the PC without any need of external programmer.

Download Manual

Visit forum for Online Discussion on this product

Customer Reviews: